Here we show a guide of how to read&clear trouble codes with Blue driver on Chevrolet Silverado 2010.
There’s OBD2 port and take blue driver plug it in.
Normally you can see a little blue light on. Once the flashing red lights tells you there’s shome thing wrong.
For now we get a check engine light and a stability control on this truck that we need to check out.
Get the blue drive installed and turn the key to the on position but not start the truck.
Regards how to setup BlueDriver to your phone, please click on below link:
How to setup BlueDriver Scanner for Android
How to Setup BlueDriver Scanner for IOS iPhone, iPad, iPod Touch
Click on the blue driver app, it’s going to load up to connecting.
Tab “READ CODES”, then tab “All System Modules”
Then waiting for scanning
We’ve got two confirmed trouble codes. One is a P0102 which is mass or volume airflow sensor “A” circuit low, the other P0113 is intake air temperature sensor 1 circuit high bank 1.
Click on the top one trouble code.
It tells us the code definition of possible causes and solutions.
Then we try to click on the other trouble code.
It also give us a repair report, include a lot of possible causes frequently reported fixed repaired mass airflow sensor wiring.
Go back and click another feature this has is “FREEZE FRAME”
The freeze frame will tell us the exact condition of this truck, all these variables and the exact moments that the check engine light come on.
Scroll down you can see the everything that’s going on in this truck. We have got two thins that have bottomed out that tells us that we probably need to check the connection on the airflow sensor.
Let’s give it a look. We find a mass airflow sensor it’s located next to the air box. This is disconnected and laying right next to it.
Plug it back in
Come back to truck and turn the ignition by key back on. Reconnecting to BlueDriver then click “Clear All Codes”.
Because we got a message that it would not allow to clear the codes while the engine is running. So we need to shut key off, then turn the key back on.
Clear all the codes again, now it is ok.